TONEWOODAMP logo
TONEWOODAMP logo

All articles

Save And Load EffectsUpdated 9 months ago


ToneWoodAmp Artist Jake Allen - Like and follow Jake Allen on Facebook!


How To Save And Load Effect presets

A "preset" is your current Parameter and Amplitude settings for your current effect. You can save these presets to memory to recall later, or overwrite our default settings with your own. 
Each effect has ten memory slots (80 total across all effects) in which you can Save, Load, or Delete your effect presets. In order to access the correct memory, you must first be using the desired effect.

Save
To save a preset:

1. Click and hold the Effects knob for two seconds.
    You will see Memory> on the display.

2. Turn the Effects knob clockwise until you see Save>. Click the effects knob.

3. Turn the Effects knob to choose a memory bank 1-10 to save. 
     If a preset already exists, you will see OVRWT #2 instead of SAVE #2.

4. Click the Effects knob again to choose your desired memory bank.
    You will see No on the display (as if asking “Are you sure?”).

5. Turn the knob clockwise until you see the Yes, and click to confirm save.


Load
To load a preset:

1. 
Click and hold the Effects knob for two seconds.
    You will see Memory> on the display.

2. 
Turn the Effects knob clockwise until you see Load>.

3. 
Click the Effects knob again.

4. 
Turn the Effects knob to scroll to the desired preset.

5. 
Click the Effects knob again to confirm the load.

NOTE: When you change effect parameters, they are maintained until you turn off the unit. If you want to use these changes next time, remember to save before shutting down.

Delete
To delete a saved effect preset:


1. Click and hold the Effects knob for two seconds.
    You will see Memory> on the display.

2. Turn the Effects knob clockwise until you see Delete>.

3. Turn the Effects knob to scroll through the 10 presets.

4. Select the desired preset and click the Effects knob again to confirm the deletion.


Was this article helpful?
Yes
No